- Smooth operation of press.
- Reduces shellplate snap and powder spilling from cases.
- Reduces run-out of press resulting in less variation in OAL.
- Please watch the video in this listing. It contains the setup and adjustment information for your kit. The video covers installation for all variations of our kit, some chapters may not apply to the kit purchased. Instructions are not supplied with the kit.
- Michigan based Tech Support
Shellplate Bearing Kit Dillon XL650 / XL750 for reducing the spills of powder when the shellplate indexes. Tactile feel for priming is enhanced and more consistent priming is achieved. Low mass detent ball and reduced power spring are included. No permanent modifications to your press required. Ejector for Dillon XL750 or XL650 This ejector replaces the wire ejector on Dillon XL750 or XL650 presses. Tuning the ejector wire is the biggest complaint people have about using a bearing kit. Our Ejector solves that problem and the inherent issue with the case binding. To install - lift off the wire injector, push this on the shellplate bolt, aim it at the chute, and tighten the set screw. It's that easy. The ejector is a zinc die casting, this is the same manufacturing technology used for many parts on your Dillon press. It will look right at home. The ejector has a heft to it when you pick it up. It is extremely durable, and heavy duty.
